Vectric Software FAQs by Students
Questions by our students with links to video answers covered in our Q&A Meetups.
- Scale this model down while keeping the detail.
- The model's already created. Is there way to create vectors from a 3D model? If you don't have the original vectors?
- I have a board and I'm trying to make it shaped like a leaf
- Doing a pocket, doing a roughing pass with a hogging endmill and then doing the last quarter inch both on the vertical depth and on the sides with a finishing mill. Is that something that's easily done or do I have to create separate vectors with offset and manually
- When there are two bits involved, the toolpaths, both have the same name. If I edit the name when creating the Toolpath, it renames both toolpaths.
- Why would you have an allowance if you could put in the exact amount?
- Anyone know any cursive fonts for laser cutting?
- How do you change the thickness of a line that you're, like a vector line that you do in VCarve?
- Recently I bought a JTech 14w laser for my Onefinity. Where can I find what the Kerf width is supposed to be?
- How do I divide an object or vector into three equal parts in Aspire?
- What can be done to minimize or eliminate warping when carving a deep 3D, would you start with a thicker piece of stock?
- Need the rib component to match the height of the bowl top ledge
- plunge rate and just plunge rate straight down
- plunge and feed rate on the bottom right hand side, and you went to the narrative, how did you get there?
- How can I round over the edges of this model during 3D cutting? Is it possible to do this after creating the 3D object from the vectors?
- I want to add an offset around the hard area down below also, I want then all the remaining areas, I want to do a texturing on it.
- I'm doing a project that requires a wavy line, the same as a sin wave. Can I create this wave in VCarve Pro?
- What precisely is fit tolerance on the curve fit tool?
- I keep running into an issue with these stair step looking , I think it may be, because I'm resizing the model on import and stretching the model causing stair step effect. I have the render quality to maximum and my toolpath preview quality set the highest as well. It does cut exactly as it looks in the screen. From the Toolpath preview and Aspire.
- Is there, an easier way to make a toolpath for each one of these different settings without having to create a toolpath for each rectangle?