2/28/2023 Replay: Round Over on Dowel, Molding Toolpath Issues, Creating Cylinders on 4th Axis, Dual Tool Cutting, Importing Photos, Inlay Lessons, Resizing Designs, Thread Milling
Question Timestamps in this Q&A:
- 00:00:00 - Intro
- 00:01:40 - How to put a round over on the end of a dowel?
- 00:09:16 - Molding toolpath issues with cutting on the correct side of the line, and also issues with the radius in the rectangles.
- 00:23:38 - How to create a cylinder with 6 or 8 sides on a 4th axis?
- 00:43:48 - Can you cut with two different tools, a larger tool to cut a little quicker, and then the smaller tool to cut the corners?
- 01:07:20 - How to get a photo from a phone or email into VCarve?
- 01:21:31 - Do you have any lessons on inlays?
- 01:23:22 - How to resize the round bookcase so the parts could fit on the CNC?
- 01:28:46 - Is there a lesson on thread milling for the Master course?
Did this answer your question?
Thanks for the feedback
There was a problem submitting your feedback. Please try again later.