7/20/2023 Replay: 3D Modeling, Scaling, Toolpaths, Design Tips & Errors and More!
Question Timestamps in this Q&A:
- 00:00:00 - Intro
- 00:01:26 - How to make display stand as pictured?
- 00:06:20 - As I get myself more into 3D modeling and sculpting, I'm wondering whether it would be advantageous to use a pen instead of the mouse?
- 00:09:02 - How to scale a 3d model?
- 00:13:42 - Can the molding toolpath be used to make a bowl where the entire center is cut out on the inside?
- 00:27:13 - Material selection in the original setup screen is different from the material in the previous session tool paths session.
- 00:32:15 - Error message when trying to add tabs.
- 00:34:31 - How would you approach making this trough shape if you didn't have Aspire?
- 00:50:32 - How do you align two components together in SketchUp??
- 01:02:40 - How to cut this design as a acrylic engraving on one of those edge lit signs?
Did this answer your question?
Thanks for the feedback
There was a problem submitting your feedback. Please try again later.