Vectric Software FAQs by Students
Questions by our students with links to video answers covered in our Q&A Meetups.
- I have a file that cut with VCarve Toolpath fine. Then I had to shrink the same to a smaller one, into a smaller flag. Now it's smaller. I can't get the detail needed in the VCarve. Is there anything I can do?
- plunge and feed rate on the bottom right hand side, and you went to the narrative, how did you get there?
- With two-sided projects, I'm confused about dowel pins, when you flip it over, the position of the wood moves.
- How to export a two-sided model, both as a stl, and also a model that can be used in VCarve Pro when using Aspire?
- The chip load on that chart per teeth, so if as three flutes, you times that number by three. Is that correct?
- plunge rate and just plunge rate straight down
- Need the rib component to match the height of the bowl top ledge
- What can be done to minimize or eliminate warping when carving a deep 3D, would you start with a thicker piece of stock?
- Base height and shape height.
- I use Aspire and I'm interested in producing boat half holes. Has anyone had experience with this particular endeavor?
- Can I select what cut to cut out first? I need to cut the inside first before cutting the outside.
- How do I get rid of uneven flat depth area in my VCarve projects? I'm using a quarter inch, eighth inch and a 16th inch up cut endmill. They always seem to be a disaster.
- How do I divide an object or vector into three equal parts in Aspire?
- How do you change the thickness of a line that you're, like a vector line that you do in VCarve?
- Anyone know any cursive fonts for laser cutting?
- How about moving a line, particular distance, like 1.5 inches to the right or left?
- How do I get the page to put it into Vectric with all the correct information for the thread cutting bit?
- Why would you have an allowance if you could put in the exact amount?
- Can you show us how to extend a line?
- How to convert image into 3D model?