2/13/2024 Replay: Text Underline, Plunge Rate for Cane Carving, Removing SVG Areas, Squaring Spindle Ends, Rotary Project Material Input, Corner Detection, Molding Path on 3D Curve

Question Timestamps in this Q&A:

• 00:00:00 - Intro
• 00:08:02 - Trying to do an underline with text and could not find the button to underline. He sees bold and italic in the create text options, but no underline
• 00:17:38 - Making a cane using the fourth axis in Aspire. What plunge rate do you recommend to eliminate the wood flexing as the bit plunges into the wood?
• 00:25:23 - How do I remove the areas attached to the bottom of this SVG to create straight lines? And then he says, actually the bigger question for me is how do I ensure that the lines are truly straight?
• 00:35:27 - I'm trying to carve just the square end of the spindle that you did in lessons number 172 and 173. Just want to make sure that I can get it square. I'm running VCarve Pro, 11.5.
• 00:40:12 - Can you confirm that VCarve assumes that all material on Rotary Project is already round when it comes in two dimensions. So when I have a piece of stock that is two inches square, should I not enter it as two inch diameter, or should I enter it as 2.8 inches, which is diagonal, and attach the file.
• 00:54:28 - If you're using square to stock, how does Vectric know where the corners are?
• 00:57:40 - Could I do a molding path on a curve 3D project?