11/9/2023 Replay: Tackling Vectric File Placement, Cam Master Post Processor, Dual Zero Plane Mastery, Pawprint Carving Challenges, Arc Distance Measurement, and Zero Plane Height in 3D Models!

Question Timestamps in this Q&A:

  • 00:00:00 - Intro
  • 00:01:55 - I have a Vectric file that opens, always opens small in a corner of Aspire working area.
  • 00:05:14 - Cam Master post processor.
  • 00:07:55 - You said you can use two zero planes to be created in VCarve Pro. Can you explain how this can be done?
  • 00:17:18 - When trying to carve pawprint into dish couldn't get the center point to carve the shape, only an oval.
  • 00:27:20 - Is there a way to measure the distance from point A to point B along an arc?
  • 00:29:16 - Have Aspire and the 3D view is a white sheet, If I go into material settings and change the material, I cannot see any change.
  • 00:40:04 - Suggestions on how to make a rubber stamp.
  • 00:43:01 - When making a 3D model and adding a zero plane as the first component, it is zero height and should be add or subtract mode?
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us