10/5/2023 Replay: Troubleshooting Toolpath Issues, Bit Recommendations, Draft Settings, and More!
Question Timestamps in this Q&A:
- 00:00:00 - Intro
- 00:02:14 - When it runs the toolpath, it plunges into the groove instead of running it smoothly.
- 00:18:04 - Am I approaching this correctly?
- 00:26:58 - On the Vectric World Wide, they were using an extended reach quarter inch end mill. Do you have a recommendation for one?
- 00:29:56 - When you're using the draft, can you set it so it'll do the outside and not the rest of the model?
- 00:36:30 - Help with table design.
- 00:54:29 - How do I set the X setting for start position?
Did this answer your question?
Thanks for the feedback
There was a problem submitting your feedback. Please try again later.