9/26/2023 Replay: Oak Leaf Details, Corian Sourcing, Rotary Profiles, VBIT Configuration, Laser Speed, and Arc Tool Mastery!

Question Timestamps in this Q&A:

• 00:00:00 - Intro
• 00:01:17 - Losing detail in his model when he previews the veins on the oak leaves.
• 00:27:12 - 3D dish to start eighth inch below the surface of the zero plane.
• 00:36:42 - Where can you get Corian?
• 00:38:04 - Would like to set up a rotary profile with the square blank so I can add text and turn.
• 00:40:57 - Could you review how to properly configure a VBIT in the tool library and Does VCarve control VBIT usage?
• 00:44:22 - Can you go over the draw a line tool?
• 00:48:18 - With the JTech Laser when I run a program, it just seems like that the steps are very slow.
• 00:58:50 - When using the arc tool, how can you set the radius without clicking on a radius and going to the text box to change and hit apply?