3/16/2023 Replay: Creating Spiral Path Shapes in Dishes, Optimizing Vacuum Hold Down with Surface Spoil Boards, Advanced CNC Bit Recommendations, Amana Bit Feeds and Speeds Information and More!
Question Timestamps in this Q&A:
00:00:00 - Intro
00:00:53 - How to make shapes that look like a spiral path Inside of a bowl or dish.
00:13:35 - Is there a lesson on surface spoil board set up to ensure the vacuum pump hold down system works?
00:14:23 - Recommendations on CNC bits that are a tier above the end mills and ball noses and taper ball nose.
00:19:07 - When you buy bits from Amana does it give you the basic feeds and speeds?
00:23:51 - If you wanted to add locator pinholes to tiling how would you space them so the material origin stays the same?
Did this answer your question?Thanks for the feedbackThere was a problem submitting your feedback. Please try again later.