4/13/2023 Replay: 3D Project Layout, Multiple 3D Copies, Cutting Corian, Image Formats, Rotating 3D Models, Two-Sided Toolpaths, 3D Finish Profile, Round Conversion Without Lathe
Question Timestamps in this Q&A:
00:00:00 - Intro
00:00:18 - How do people lay out projects in VCarve that require, or that are 3D in nature?
00:12:07 - Can you have multiply copies of the same 3D model in one job using VCarve Pro?
00:15:21 - Can I use spectra bits to cut Corian or do I need special bits to cut it?
00:31:44 - What is the best format to save a picture in Aspire to work on a 3D project?
00:45:18 - In 3D rotary project can you rotate model 45 degrees and continue carving to eliminate the undercuts?
00:54:03 - Would it be possible to route all four sides of an STL model with two-sided toolpaths?
01:02:42 - When doing a 3D finish toolpath, is there a way you can have the toolpath do a finished profile pass?
01:13:46 - When doing a rotary job, Is there a way to make a square piece into round almost like a lathe if you don't have a lathe?
Did this answer your question?Thanks for the feedbackThere was a problem submitting your feedback. Please try again later.