5/2/23 Replay: Z-Zeroing, Curved Leg Design, Inlay Formulas, Quick Grid Measurements, PC Suggestions, Toolpath Creation, Round Over Techniques, Drag Knife Setup, and More!

Question Timestamps in this Q&A:

• 00:00:00 - Intro 
• 00:00:45 - Where do I zero my Z on the project after a bit change?
• 00:02:27 - How would I create the curved legs on this project?
• 00:12:53 - Is there a formula for inlays?
• 00:17:19 - When you use the grid lines how do you know the measurements of them quickly?
• 00:20:05 - Any suggestions on computers since Vectric now uses the graphic processor for parts for its workload?
• 00:36:18 - Trying to make a toolpath that will shave a small amount of material off the edge along the Y axis.
• 00:47:34 - Is there a way in Aspire or any of the Vectric software that there's an automatic save?
• 00:53:17 - How to create a half inch round over on the outside of a board.
• 00:58:07 - Would you be able to show the drag knife setup gadget and VCarve Pro and installing the tool library?
• 01:01:49 - Help with putting distorted text on the outside of a circle.
• 01:05:09 - Problem moving a master file to a template to cut multiple copies at once.