5/11/2023 Replay: Chamfer Toolpath, Changing Start Depth, Birdhouse Design, SketchUp Faces, Pilot Holes with V Bit, Upcut End Mill Usage, Identifying Worn Bits, Saving Diamond Pattern as Template

Question Timestamps in this Q&A:

• 00:00:00 - Intro
• 00:01:11 - Help using the chamfer toolpath on the edge of a shield project.
• 00:06:41 - Would it be okay to change the start depth on the final profile?
• 00:08:42 - How to create a birdhouse with a face on it?
• 00:21:20 - How to get faces back on SketchUp?
• 00:29:47 - Any recommendations on how to set a pilot hole with a V bit or what the formula is to find the right angle bit?
• 00:53:42 - Can an upcut end mill be used for pocketing toolpath and roughing toolpath?
• 00:54:20 - How do you know if your bit is bad after using it for awhile?
• 01:02:19 - Last Q&A showed a diamond pattern for the meat tenderizer, How do you save that as a template and can it be resized?