6/8/2023 Replay: Scaling, Chamfering, Cribbage Boards, Boring Bits, Spiral Ramps, Circle Creation, Z Safe Height, Model Separation in Vectric
Question Timestamps in this Q&A:
00:00:00 - Intro
00:02:00 - Is there an easy way to scale it up to basically a different size in lesson 84?
00:03:16 - Cribbage board file adding a chamfer on the edge.
00:09:13 - Is everyone using the three millimeters from tools today for cribbage board and does it create any issues for the pins that are sold on Amazon?
00:19:18 - Does the adapter for the boring bit increase flexing of the shaft?
00:20:57 - For pecking only, could a boring bit be used for a spiral ramp?
00:24:12 - Looking for help creating an eight inch diameter circle with a six inch hole in the middle.
00:40:28 - Where do I set the Z safe height in Vectric?
00:41:42 - Is there way is he able to separate the model based on each color?
Did this answer your question?Thanks for the feedbackThere was a problem submitting your feedback. Please try again later.