00:14:25 - Are you re zeroing the Z to the surface of the original material or to the top of the platform there?
00:17:01 - Why I couldn't, I have just used a 30 degree V bit for each segment then cut a slot open instead of using the molding toolpath?
00:17:50 - Is there any way you can get a printable hard copy of both the CAD CAM menus for VCarve Pro?
00:19:15 - Making a quarter inch wood screw countersink an 82 degree slant. I think I can get it to do a flat bottom hole countersink but no go with the angle one.
00:32:11 - In VCarve, can you clip areas you don't want the molding toolpath to cut?
00:35:47 - Can you have multiple example three or more profile transitions along a two rail sweep?
00:45:15 - How would you go about matching up molding in your house to VCarve it out yourself?
Did this answer your question?Thanks for the feedbackThere was a problem submitting your feedback. Please try again later.