7/11/2023 Replay: 3D Toolpaths, Designing, Bit Evaluation, Epoxy Staining, and Vectric Techniques

Question Timestamps in this Q&A:

• 00:00:00 - Intro
• 00:01:14 - When he runs the 3D finish toolpath, the quarter inch end mill cuts fine. The eighth inch and 16th inch seems to be the problem.
• 00:14:07 - How to make 3d files like this?
• 00:24:01 - Can you look at the toolpaths to make sure everything looks okay on this scoreboard file?
• 00:33:33 - Is there an easier way to do the numbers on this cribbage board?
• 00:42:34 - What you use for a rule of thumb to know when your bits getting too dull to use?
• 00:47:46 - Did you say you could modify a 3D imported object in Vectric?
• 01:00:26 - Help with file and x molding y.
• 01:04:04 - Any experience with a downcut v bit?
• 01:04:50 - Can we carve this 3d model using two sided?
• 01:08:40 - Is it common for the epoxy To look tinted when you apply stain over it?