00:00:54- Does Vetric have an option for a "Park" position?
00:12:34 - How would you go about designing the handle of a knife in Aspire?
00:16:18 - Can you explain rest machining advantages and when to use it?
00:37:01 - Where would you use ball mill versus tapered ball?
00:40:03 - How would you add Amana 56170 bit to tool database?
00:46:17 - Is it better when entering your tools into the database instead of going with what the website says to actually measure with the caliper, like the actual dimension?
00:50:37 - Is there a way to get the toolpaths to list what tool you're actually using instead of clear one, clear two?
Did this answer your question?Thanks for the feedbackThere was a problem submitting your feedback. Please try again later.
